peteb
New Member
Posts: 2
|
Post by peteb on Sept 12, 2021 6:16:45 GMT
Hi just taking the CT-4 out for a spin for the first time but I'm having an issue with the Throttle. I am using the Honeycomb Bravo throttle configured with 1 each throttle Prop and Mixture levers. Mixture and Prop - no issues but when advancing the the throttle to about 90% it immediately flicks back to the rear stop. I have re- configured and changed throttle slots but still the same result. I have tried the throttle with no alterations in MSFS with no issue there. I have tried it with experimental on and off makes no difference. Any ideas where to look ?? Cheers Pete
|
|
|
Post by VSL-Admin on Sept 12, 2021 6:30:54 GMT
Hi just taking the CT-4 out for a spin for the first time but I'm having an issue with the Throttle. I am using the Honeycomb Bravo throttle configured with 1 each throttle Prop and Mixture levers. Mixture and Prop - no issues but when advancing the the throttle to about 90% it immediately flicks back to the rear stop. I have re- configured and changed throttle slots but still the same result. I have tried the throttle with no alterations in MSFS with no issue there. I have tried it with experimental on and off makes no difference. Any ideas where to look ?? Cheers Pete Hello Pete, The VSKYLABS CT/4E engine management and assignments are using the default ones in X-Plane, just as it is in the default C-172 and alike. From your description I understand that you may have a configuration issue which is related to your throttle hardware rather than having a specific add-on related issue. For start, please try your throttle with one of the default aircraft, say the C-172 and see how it works. Let me know if it worked well or not, and we will be able to proceed into this. Thanks!
|
|
peteb
New Member
Posts: 2
|
Post by peteb on Sept 12, 2021 7:47:00 GMT
Hi there - tried again and it is definitely something in XPlane not the CT4 sorry to bother you, my bad. Cheers Pete
|
|
|
Post by VSL-Admin on Sept 17, 2021 22:08:53 GMT
Hi there - tried again and it is definitely something in XPlane not the CT4 sorry to bother you, my bad. Cheers Pete Hi there, Great! Thanks for updating with your status, you did not bother me at all
|
|