|
Post by chasdemp on Oct 1, 2022 23:21:34 GMT
Hi,
I have been operating the C47/DC3 in XP12 using the XP12 download since it has been available.
I have noticed there is no response from the autopilot when engaged, has this been reported. I realize that XP 12 is early release so I would just like to register the problem.
Regards chasdemp.
|
|
|
Post by VSL-Admin on Oct 2, 2022 12:59:29 GMT
Hi, I have been operating the C47/DC3 in XP12 using the XP12 download since it has been available.
I have noticed there is no response from the autopilot when engaged, has this been reported. I realize that XP 12 is early release so I would just like to register the problem.
Regards chasdemp. Hi! This was just tested and all seems to work as expected. Please verify that you don't have any assignment conflicts with key/button assignments for the autopilot. In addition - there are two autopilot interfaces in the VSKYLABS C-47: The Sperry and the S-TEC 55. You must engage the autopilot from the switch/lever that is located on the lower LH side of the front/pedestal panel. Then, after you hear the aural feedback that the autopilot is connected, you can use the Sperry knobs *or* the S-TEC modes. Let know if you need further assistance!
|
|
|
Post by chasdemp on Oct 13, 2022 0:53:45 GMT
Jetmanhuss Hi! I do not have any key/button assignments for the autopilot. I do not get any aural feedback indicating the auto pilot is engaged. Regards chasdemp
|
|