r3821
New Member
Posts: 4
|
Post by r3821 on Feb 2, 2023 14:30:25 GMT
Hi,
(I think since the latest update which fixed engine not restarting)
The "Pumpe" CB will not latch in. This happens even when I the mouse to interact withh all external interfaces removed.
Is this a known issue or are there any checks I can/should do please?
Still loving this aircraft it is a beauty.
Thanks
Julian
|
|
|
Post by VSL-Admin on Feb 2, 2023 14:51:29 GMT
Hi, (I think since the latest update which fixed engine not restarting) The "Pumpe" CB will not latch in. This happens even when I the mouse to interact withh all external interfaces removed. Is this a known issue or are there any checks I can/should do please? Still loving this aircraft it is a beauty. Thanks Julian Hi Julian, Thank you for reporting. This minor issue was just fixed (no version change since it is very very minor). For engine not restarting - make sure to set the pump CB out when shutting down the engine using the ignition switch. Or else it will be flooded and hard to re-start. Thanks again!
|
|
r3821
New Member
Posts: 4
|
Post by r3821 on Feb 2, 2023 15:00:32 GMT
Hi - thanks for the reply. I only found it because I was testing a new interface to control the CB I'm building, and I couldn't figure out what I was doing wrong 🤦 Is there any way to make the fuel tap an on - off external action? At the moment a push button toggles it but I wanted to build a physical tap with maybe an IR LED and sensor to mimic the VR tap. The engine problem is fine now so no worries, I can wait! Best wishes Julian
|
|