|
Post by alpinewarren on Jul 6, 2021 2:14:59 GMT
1st flight anomaly - Climb out - Straight and level - Autopilot on - Ball centered - Aircraft cruising banked about 5 degrees left???
Experimental mode enabled...
I'll try it again later...
Ideas?
-- Warren
|
|
|
Post by VSL-Admin on Jul 6, 2021 5:42:37 GMT
1st flight anomaly - Climb out - Straight and level - Autopilot on - Ball centered - Aircraft cruising banked about 5 degrees left??? Experimental mode enabled... I'll try it again later... Ideas? -- Warren Hi! Yes, you may need to trim the rudder. It is trimmer to the right for takeoff, and needs to be trimmed during flight. Rudder trim indicator is on the left portion of the front panel.
|
|
|
Post by alpinewarren on Jul 6, 2021 14:44:38 GMT
Yeah it was trimmed right and ball was centered. But last nights flight went fine. Must have been an issue on that load only.
|
|
|
Post by gregga63 on Sept 16, 2021 22:48:51 GMT
The CT4 looks amazing, but it's absolutely killing the frame-rate using VR. The sim turns completely jittery to the point of having to force close X-plane. I don't have this issue with any other aircraft. Any ideas?
|
|
|
Post by VSL-Admin on Sept 17, 2021 22:16:47 GMT
The CT4 looks amazing, but it's absolutely killing the frame-rate using VR. The sim turns completely jittery to the point of having to force close X-plane. I don't have this issue with any other aircraft. Any ideas? Hello, and thanks for your feedback! The VSKYLABS CT/4E Project is not a highly-demanding on resources, when compared to similar 2021 era high quality aircraft add-ons (of any developer). However, using X-Plane, especially in VR is quite a demanding effort, and depending on your hardware setup (CPU/GPU etc..) you may experience a struggling system, and lower FPS when comparing to one of the default aircraft which are very low on resources. I suggest to try and manage your rendering options, reducing HDR, Anti-Aliasing, maybe objects density, reflections etc...to get a better "sweet spot" between the looks and FPS. If you are interested - please specify your system specs and I will be able to direct you more accurately.
|
|